Photo may contain optional equipment.
STOCKER AL
All aluminum bumper pull stock trailer
Standard Features
Available Sizes
14' floor length w/2-3500# axles, 15" tires & 6-hole wheels
16' floor length w/2-3500# axles, 15" tires & 6-hole wheels
Dimensions
6'-6" body height
6' body width
28" tongue length
Undercarriage
Rubber torsion axles with four wheel independent suspension and greasable hubs for easy lubrication
Electric brakes on all wheels
Radial tires on silver modular wheels with chrome center caps
Spare tire rack only
Coupler & Jacks
2-5/16" coupler and safety chains with hooks
Top-wind jack with caster wheel
Emergency breakaway system: switch, cable and battery box complete with battery and charger
Design Features & Hardware
Extruded aluminum top rail
One piece aluminum skin roof with 1" x 2 1/2" tubing bows on 2' centers
4' sides with two air gaps
12" aluminum plank floor
9" extruded aluminum bottom frame
Two rubber mounted optical windows in front
Aluminum tread plate gravel guard (standard on 7' tall models only)
Rubber dock bumper below rear door
Chrome trim with colored vinyl insert on nosecap
Plexiglass rails
Tag bracket
Load Area Equipment
48" double lined front sheet
Side access door on curb side
Center gate with spring loaded hold back and slam latch
Full swing half sliding rear gate with spring latch, heavy duty cam bar and eight ball bearing rollers
Four inside tie rings; no outside tie rings
Lights
DOT required lighting
CM Trailers reserves the right to make any change in paint, design, or construction as necessary for engineering. All visual representation, specification, and dimensions are based on the latest product information available at the time of publication. Some of the equipment shown or described is available at extra cost. At no time will any of the material or information contained in this publication have any justifications for resolving disputes. All axle ratings will be listed as per FMVSS 120, Section 5.1 states, the maximum load rating of the tires and rims fitted to an axle shall not be less than the GAWR specified on the certification label.
